This section talks about using LCDproc with LCD displays that use the CFontz633 chipset.
DEVICE
Select the output device to use [default: /dev/lcd]
may be serial device or USB device in serial emulation mode.
WIDTH
x
HEIGHT
Select the LCD type (size) [default: 16x2]
CONTRAST
Set the initial contrast.
Legal values for CONTRAST are 0 - 1000.
If not specified, it defaults to 560.
BRIGHTNESS
Set the initial brightness [default: 1000; legal: 0 - 1000]
BRIGHTNESS
Set the initial off-brightness [default: 0; legal: 0 - 1000]
This value is used when the display is normally
switched off in case LCDd is inactive
1200 | 2400 | 9600 | 19200 | 115200 }
Set the the baud rate for communication with the LCD. If not specified, the default is 19200.
yes | no }
Set the firmware version (New means >= 2.0) [default: no; legal: yes, no]
Currently this flag is not in use, there is no such thing as NewFirmware. ;=)
yes | no }
Reinitialize the LCD's BIOS [default: no; legal: yes, no]
I want to reboot the LCD to make sure we start from a known state